The "X" indicates the throttle servo working range has not been set up or was not set up correctly.

The "O" indicates the throttle servo working range has been set up correctly.

Governor control for gas/nitro engine

(Not covered in this review)

Description

Tx Control, Governor Control

Select the appropriate mode.

TX Control for electric helicopters.

Governor Control for gas/nitro helicopters.

Description

SET-MAX (left button)

Make sure throttle hold is OFF.

Switch your flight mode to IDLE1.

Move your collective stick to maximum position. and click on SET-MAX button.

SET-IDLE (middle button)

Switch your flight mode to NORMAL.

Move your collective stick to lowest position and click on SET-IDLE button.

NOTE:  Make sure when the stick is at its lowest position that the throttle curve percentage is at zero.

SET-STOP (right button)

Switch throttle hold ON and click on SET-STOP button.

Click on WRITE button.